Please use the PVC card(85mm x 55mm) CR-80 standard. When turning the characters plate, please don't drop down the hand-haft. When switch the embossment size, please ward off the card frame slightly to avoid damage.
Never put hand or other hard objects into the machine. Please move the card frame to the left end when not using the machine.If the imprinted character may be deeper or shallower, undesirable, then it can be adjusted by adjusting screw in the regulation. Means:use the Z outside-hexagonal spanner along with the code sprinter to a little loose the hold-down nut, and then inside-hexagonal spanner with the code sprinter to adjust the middle regulating screw. Attention:turning the regulating screw in clockwise may deepen the typed characters while clockwise turning may lighten the typed characters. After finishing, please use the inside-hexagonal spanner with the code sprinter to make the regulating srcew stable, and then use the Z outside-hexagonal spanner to fasten the hold-downscrew. Kindly Notice: Due to the effort saving design, please do not pull the lever too hard during your operation in order to protect the machine. Package list: - 1 x PVC Card Embossing Machine - 1 x Punch Handle - 1 x Handle Fastening Screw - 1 x Sample PVC Card - 1 x Set of Hardware - 1 x User's Manual.
Usually it cost about 35USD-50USD. The item "72 Letter Character Manual Embosser Machine PVC Card Credit ID VIP Stamping dl45" is in sale since Monday, November 12, 2018. This item is in the category "Business & Industrial\Printing & Graphic Arts\Screen & Specialty Printing\Stamping & Embossing". The seller is "onemoredeal" and is located in Shenzhen. This item can be shipped worldwide.